Current-Voltage Measurements in a 2G YBCO Coil

Abstract

Abstract- The Oak Ridge National Laboratory in collaboration with American Superconductor Corporation and Cryomagnetics Inc. has designed, fabricated, and tested an HTS coil wound with second-generation (2G) YBCO coated conductor tape. The purpose of the HTS coil project was to study the quench characteristics in 2G YBCO coils at 77 K and lower temperatures (~ 30-45 K). These quench characteristics were investigated in both a pool boiling LN2 environment and in a conduction cooled configuration at ~ 30 K and 45 K. Transport critical current (Ic) measurements taken on the very first thermal cycle of the YBCO coil in pool boiling LN2 showed an Ic ~ 31 A corresponding to a central magnetic field of 0.32 T. The measured Ic value was consistent with the calculated value using the calculated maximum perpendicular B-field component and the measured short sample Ic at 77 K. Subsequent Ic measurements taken in the conduction cooling configuration at 34 K and 45 K, showed a steady-state Ic ~ 45-49 A and 38-44 A, respectively. These Ic values were significantly lower than the calculated value assuming a literature derived temperature dependent Ic of the 2G YBCO tape. A steady degradation was observed in the Ic of the coil with each successive thermal cycle. In addition, the coil was also pulse tested up to 1-T in non-steady state transient conditions and for ramp rates varying between 0.01 and 5 A/s. The problems and limitations encountered during testing of this new type of 2G coil is briefly discussed.